5 Steps To Installing Land Drainage

5 Steps To Installing Land Drainage

The following five materials are required in a land drainage installation. They are drainage piping, which you can get from EasyMerchant at competitive prices, the fittings and the shovel. If it’s open piping, you will need a fabric filter. Gravel is also important to facilitate drainage. Remember for proper drainage, it must be on a sloppy landscape to make it easier for water to flow easily. This also prevents pooling at the low spots. A few tips will help you to install land drainage properly.

Here are the 5 steps to installing land drainage:

  1. Identify the route

This is the most important step. It will determine if the drainage system will work or not. You need to seek professional guidance when installing the drainage. An expert can recommend the right route the land drainage should take. You will also get information regarding the right materials to use and where to get them. Researching online can also help you understand the basics of installing land drainage. The basic principle is to create a downward slope.

  1. Get the pipes and other building materials

When you get all the materials required ready, then it becomes faster and easier to install the drainage. The most important materials are the pipes, ducts and their accessories and the filters. There are various types of pipes. You should know the purposes of each of the pipes. It is important to get the pipes from quality dealers so that they can last for long. This way, the system will last for a long time without any need for repairs and maintenance. You may choose the closed pipes for diversion and open-ended pipes if you want to drain the water away.

  1. Trench preparation

The measurements for the trench may vary but it is usually eight inches wide and around seventeen inches deep. Depending on the volume of the water you may adjust the measurements accordingly. When shoveling the trench, remember to set aside the sod. You will require it to cover up the trench later. You should also ensure that the bottom of the trench is firm enough. It should also be sloping down to the drainage. This way, it’s easier for the drainage to work.

  1. Installing the pipes.

Before you install the pipes, it’s good to line the trench with gravel. For open drainage, you should also use the filters. A filter fabric blocks debris from entering the drainage system. If too much debris enters the pipes, they may cause a blockage.

  1. Finishing

After installing the pipes, the final step is to do the finishing. You must first refill the sod to cover the trench. You should do it carefully to avoid damaging the pipes and filter fabric. Ensure that you level the retrench and that you leave the place neat. It’s important to mark the lines to avoid disruptions in the future.

Installing drainage pipes is not easy. It is advisable to hire a contractor since they have the expertise and experience. If you opt to do it yourself, contact a contractor in case of any doubts or clarification.